Technical Installation sticker professional.
The sticker is installed. Holds that science is one that is full of advertising must be everyone. Process generally people do not have contact sticker. May be thought intractable. But in fact, the sticker is installed, if we prepare well. The equipment and tools are full. We can install without having to worry that the fallout or bubbles.
The first step we have prepared the following equipment.
1. The tire iron or cut sticker.
2. Water lubrication at installation sticker (water, shampoo, soap, water, water, Sun light).
3. Hair dryer, cigarette lighter.
6. Transparent tape.
7. EBS state prosecutor (the water injection).
Now we see how to install the stickers.
1. Peeling back the paper sticker.
2. The injection water in a spray adhesive and spray the area to be with us. To the sticker that we install is the flexibility of mobile ยื. If we do not spray the water is to occur. When we installed does not match. We will not be able to exit or to move sticker. And can not be rolled in to the bubbles (for fresh water injected much to recommend it).
3. When you put stickers on where we want then we will make bubbles using a rolled iron sticker. This depends on the experience factor. Reed sticker that can prevent bubbles have much more better.
4. The final step is to check more bubbles. If there are bubbles. We can solve problems by using the hair dryer's possible. Breathed the sticker is lower. And then rolled again. If no bubbles are not rolled down. We can use the Copy Potter slash light point with bubbles (but this does not actually do not ก้. Sticker time because it will dry shrinkage clearly has the background) if the bubble is another way to solve the final problem is. Point to a lighter area is Ang eggs and iron again.