Technical Install sticker on glass

Installation sticker on the glass. This installation required a human need. Installed on more general label. Because the glaze, we need to measure area before installing glass. The calculated width x length and a Center for the glass.

    The first step we have prepared the following equipment.
1. The tire iron or cut sticker.
2. Water lubrication at installation sticker (water, shampoo, soap, water, water, Sun light).
3. hair dryer, cigarette lighter.
4. Ruler.
5. Cutter.
6. Transparent tape.
7. EBS state prosecutor (the water injection).
8. Lighter.

After we finished preparing equipment we have to find a Center of glass if the meat glaze must be at the center. For convenience. If we could do in nature 1:10 or 1:100 if the meat is a large paper than A4.

Then we need to make paper copies to be back sticker. In the copy. Suggest that only 1 in 3 for copies of letters only. To see the base sticker Guides line to a line of line. If the meat of characters is much more we should use transparent tape Marking Tape or paste the text before copying sticker.

Sample installation sticker on glass.


Installation sticker letters glaze it. If the installation technicians skilled sticker. They do not need to spray water. Because the injection of water in some situations. Installation will be more difficult in environments such as humid air. We should avoid the water spray.
In addition, the large font or logo that is only large impervious surface. We need to inject water.
For the installation disc, Inc. You are Jay. Unlike letters to ingrain. J. You, Inc. is because we need water to be rid of bubbles, we must be very careful about cleanliness. Because if there is dust stuck on the adhesive sticker. We will make changes difficult.