Technical Installation sticker cars

The next car sticker. Will be more difficult than the sticker on the label and glass. Because it will be a rounded surface that is not flat. Therefore, the installation technician must be experienced to do the sticker. To be able to install vehicle sticker.

    The first step we have prepared the following equipment.
1. The tire iron or cut sticker.
2. Water lubrication at installation sticker (water, shampoo, soap, water, water, Sun light).
3. Have hair dryer, cigarette lighter.
4. Ruler.
5. Cutter.
6. Transparent tape.
7. EBS state prosecutor (the water injection).
8. Lighter.

After that, we need to measure vehicle length X width. Match the rounded concave of the vehicle. This technique will be successful. The main one is based on vehicle design. Which must measure the size of the car and rounded estimate accurately estimated. To design out into the computer. You can use graphic design programs such as Photoshop, Ilustrator, 3D Animation, etc..

Then we put the sticker in order to cut down on the car to place first. We copy after a paper sticker wash out about half of the characters (letters sticker) If a sticker, Inc. J. Richmond is not a cut, we need to inject water. Injection on the sticker to be able to move sticker and no bubbles when we set at the sticker and then we make bubbles rolled out by the press if there's eggs that we used the hair dryer. Blow sticker on while washing. Then gradually to mangle again. Suggest that the point in doing this with all the bubbles.
Suggestions. The next car sticker should be people who have experienced sticker and then install. Otherwise, the sticker may be damaged or was not related to deform.